Re: Johnson DT38 Brush Alignment Tool

Home › Forum › Ask A Member › Johnson DT38 Brush Alignment Tool › Re: Johnson DT38 Brush Alignment Tool

January 13, 2017 at 11:20 pm #50986
willyboy
Participant

    I measured the surface they ride on on my calipers and it was 1.810 so I figure if I get the brushes as close as possible to that I should be ok. Have to clean some surface rust off the flywheel magnets and then attempt to get the flywheel back on without bending the brushes back out of whack. Wouldn’t mind having one of those adjustment blocks if they were still out there to be had. Thanks