Home › Forum › Ask A Member › KE-7 crank removal questions › Re: KE-7 crank removal questions
January 4, 2017 at 3:32 am
#50278
Hi, Get out your can of PB Blaster and soak the top crank bearing after you have removed the top crank seal. Then soak all around the center bearing (reed block) and let sit a day. Then get (2) 3/8" dia. x 3/4" long bolt & nut. screw together to support the (2) crank fillets when you start to press out the crank. You have to do this or you will damage the crank. You might also use some heat around crankcase bearing area. Good luck.