Re: Eisemann Coil Swap on Sears Waterwitch

[chris-p]

Thanks Richard.

I removed the whole lamination, re rivet them back together. Slid the new coil on, tight fit but it worked. I did not have to remove any of the width, only 1 lamination to make it work.

The bad news is that it doesn’t work with the plug wire sticking up. The magnets hit it. You can see in the picture attached. You have to mount the coil so that the plug wire is facing down, then you have to drill out a hole in the mag plate to accommodate the protrusion and plug wire.

Just for those of you in the future planning this conversion.