Re: Ugly Duckling

[bullie]

Ok. Serious question this time. The coil I purchased has 3 wires and the coil on my motor has 4. The new coil doesn’t have the ground wire that attaches directly below the coil. Will this work ok? I have halted the great soldering experiment until this little issue is worked out.

Note: Concerning this little ground wire attached directly below the coil to the mag plate. I noticed it spins freely in either direction. I doubt that is normal. I did check my new coil and all seems good. I just don’t have the experience to know if replacing old coil with the 3 wire coil is ok.