Re: There has to be a better way to remove the prop shaft seal

Home › Forum › Ask A Member › There has to be a better way to remove the prop shaft seal › Re: There has to be a better way to remove the prop shaft seal

May 10, 2015 at 6:02 pm #15671
jeff-register
Participant

    Reminds me of Mercury seals. Try using a cut off wheel on a dremel to start pealing it off. My Hat’s off to you getting that far with none or little damage. You might try heat too. I’ve had impeller housings glued in with sealer & needed to get the goop hot in order to get it to release.
    Keep up the good work!!