Re: 9.5 hp 1966 mdl 9622a lower gearcase

Home › Forum › Ask A Member › 9.5 hp 1966 mdl 9622a lower gearcase › Re: 9.5 hp 1966 mdl 9622a lower gearcase

December 8, 2016 at 8:34 pm #48879
JACQUES
Participant

    Gentlemen my concern is about the pump’s rubber seal for the DRIVE shaft … the rubber seal sits squarely on top of the water pump and on my 9622a the rubber I.D. does not rub against the drive shaft …..it is about 1.5 times as wide as the drive shaft itself

    so the question here is…. is the grommet/seal intended to only buckle (seal) up against the dow tube in which the drive shaft spins or is it intended to actually seal of any water from shooting up in the "down tube" along the drive shaft itself ??

    thanks

    Joining AOMCI has priviledges 🙂