Re: To hone or not to hone

Home › Forum › Ask A Member › To hone or not to hone › Re: To hone or not to hone

September 24, 2016 at 12:22 am #44625
David Stanton
Participant

    US MEMBER PAY BY CHECK
    quote Chris_P:

    If you are putting the old rings back in, keep them in the same spot on the same piston.

    Good advice, especially on motors where there are orientation pins to keep the rings from working around the piston. I’ve been known to move old rings to replacement pistons, keeping them in the same orientation if the old rings are OK.