Re: Rope starting Elgins/West Bends…

[joesnuffy]

I was working on a 16hp Bailamatic Scott Atwater and took off the rope plate and it fits onto the 12hp West Bend Flywheel using the 3 beleveled screws. The part number for a 10hp Scott Atwater rope plate is 3335-4110 I think its what a Scott 16hp uses but not sure someone reading this may know if their the same.

I found this one on ebay for a 7.5 hp scott but it kinda shows what it looks like looks like it would work well for a rope back up starter on a west bend. Gives an idea of what it looks like. I may put one on mine as a back-up.

http://www.ebay.com/itm/1953-54-SCOTT-A … 9j&vxp=mtr

Hope that helps,
Joe

https://SecreLocal.com - - No Verify - Anonymous Adult Dating -