Re: 1980 Evinrude 85 hp trim and tilt

[mgsolakis]

There were too posts in which that grooved pin could fit into the base. I put a in the bottom hole. I don’t think this motor has a trailer lock but I have used my engine hoist to raise the bottom of the motor up. I think the rams are out all the way but it’s hard to tell. In order to raise the motor up I loosened the screw on th side and pulled the motor up as I lowered it the rams came out. Hopefully they are all the way out. I assume I add oil to the opposite side of the assembly there is a big screw hole. Is it best to use a pump? As always I thank you for all the tips.