Home › Forum › Ask A Member › 1963 Johnson QDL-24 10HP › Re: 1963 Johnson QDL-24 10HP
I understand what you are saying, but mine is not flat on one side nor is the throttle shaft. It will go on in any position. I have had it on in a few so I know this is correct. It is not exactly as it is in the diagram, that was just to show what I am talking about.
At first set it at idle and when you would twist the grip to full it would open the carb up yet it would not reach full RPM because the mag was not advanced enough. So I reset it with both at WOT as stated above. It does run fine, but I am afraid of advancing too much creating other problems like creating excessive heat, etc.
It is running good, just want to ensure it does not need to be in a specific position to not create long term problems