Home › Forum › Ask A Member › Newer motor problem › Re: Newer motor problem
OK, well I’m hoping you did the stop circuit elimination test before going through the trouble of pulling the flywheel. I don’t think there are any fiber washers mounted under the powerpack/module, did you mean to say the coils? Did you remove the charge coil to check the resistance, or just unplug the leads? If you removed the charge coil, you will need the locating ring to orient it properly onto the mag plate. In any event, I don’t think it will hurt anything to remove the fiber washers from the coils. I would reuse them if they are there, just check coil strap and powerpack/module grounds after resintalling the coils and ground leads.
You will probably end up replacing that carb plastic cover, the throttle linkage puts too much pressure on it, don’t think epoxy will hold. I am hoping the lastest pieces are more durable, get ready to choke on the price though.
So again, did you check the powerpack/module ground with an ohmmeter? Did you unplug the stop circuit connector and recheck for spark?