Re: Newer motor problem

[wyo307]

Thank you fleetwin. I am not scared of it it is just unfamiliar to me. Yes the lanyard is installed but I haven’t checked the switch yet. Yes it is a ufi system. I am comfortable checking the switch, charge coil, and ignition coil but the power pack itself is a little confusing to me. When you say to check the ground coming off of the power pack for less than one ohm where are you testing between? I am assuming the ground and where else? I found the service manual on boatinfo so I have been reading about it this morning so hopefully I will have it diagnosed this afternoon.

Also where the ignition coil is mounted to the block which is also where all of the grounds tie in there are nylon washers behind the coil. Does this coil need to be insulated from ground except for the ground wire that comes off of the coil?

I think that I either have a kill switch or ground problem but I am trying to figure out where it would be at this point.

Thanks again for the help.