I’m glad I took the gas tank apart. Lost of powdery corrosion and chunks of
old sealer loose inside, that must have squeezed out of the joints when put
together last. After I sand blasted I see that I have lots of little pits in the bottom half,
and one pin hole that I could see light through.
There was no gasket between the halves. Should I bolt it up together good
and use gas tank sealer to seal the pin hole and the tank halves, or
seal the tank halves first with some kind of sealant, then use gas tank sealer
for the pin hole?
Attachments:
Prepare to be boarded!