Re: Gettin into the lower unit

Home › Forum › Ask A Member › Gettin into the lower unit › Re: Gettin into the lower unit

April 23, 2015 at 12:46 pm #14562
hag
Participant

    Thanks Jeff,

    Well, I like your spanner tool I think I will make it but still get one from the hardware store also not too expensive.

    Can you post picture of the modified box wrench? The pinion gear nut is proving to be a pain.

    As for the other gears, the forward gear is fine and intact, the reverse gear had some damage to it along with the bearings. That was replaced with the new bearing carrier.

    Once I get pinion nut off I can check the alignment of the teeth of the new pinion with the rest of the teeth.