Re: control box wiring question

[johnyrude200]

Hi Dan,

I found a good spot to install the warning horn under the cowel, and have a purple lead running from the horn to the key switch terminal A. The brown wire off the sensor is fed to the horn as well as per the wiring diagram. Just double checking where the purple wire goes from the key switch back to the wiring harness (in this case, there is no red plug with my set up just bullet connectors) to see where that should go, and apparently from everyone else’s comments, it is not necessary to have that lead to anything.

This motor was originally a 30hp remote control motor, now converted to tiller control with electric start and I simply installed the typical wiring set up from the control box on the control panel of the motor (as in, where the choke switch/kill button traditionally would reside). Kind of a sweet set up, might even do this on a personal motor someday. But it sure took some time to transplant everything!

Let me know if I’m missing something here!