Re: evinrude 5.5 1956 converting to fuel pump

[JACQUES]

to make the triangular bracket I used some 90 angles.
one was cut about 1 inch at the base corner to bolt into the rear cross bar (where the rubber bumper are)
the other 2 parts of the triangle were just cut pieces of common 90 degree angles, cut to fit the mounting holes of the pump
I used nylon self locking nuts to keep the assembly from vibration loose.

this snugs the pump body next to the cyl. wall and allows the cover to fit nicely

Joining AOMCI has priviledges 🙂