Re: Rebuilding a 1956 Evinrude 7.5hp

Home › Forum › Ask A Member › Rebuilding a 1956 Evinrude 7.5hp › Re: Rebuilding a 1956 Evinrude 7.5hp

May 9, 2016 at 4:23 pm #36296
chas56x
Participant

    US Member

    I measured the OD of the crank pin and it measured 0.0815 on both upper and lower crank pins. I then measured the ID of the connecting rods at the measured 0.0825 on both. This makes for a one thousandths of an inch clearance. I would think the clearance would be OK?