Re: Mercury Mark 6 Drive Shaft Repair?

Home › Forum › Ask A Member › Mercury Mark 6 Drive Shaft Repair? › Re: Mercury Mark 6 Drive Shaft Repair?

April 19, 2015 at 1:16 pm #14269
Buccaneer
Participant

    US Member

    Dave, I sent you a PM.

    Westwind, brazing is something I could do. Suppose the
    grooved area would have to be V’eed out and cleaned up
    a little. Could chuck it in the lathe, cut down the braze
    close, then emory cloth it smooth.
    Not sure what the heat from the brazing would do to the strength
    or temporing of the shaft though?
    Thanks,

    Prepare to be boarded!