I don’t have a schematic but here’s a link to a thread explaining the PO wiring.
viewtopic.php?f=2&t=4660&hilit=po+15+wiring
I just picked up a PO myself and can’t wait to try it out! First though, I have to make a new end cap for the tiller handle. The original one is Bakelite or something and is chipped. The new one will be made out of Acetal (Delrin) plastic. In the meantime, I threaded the old one to accept a cheap kill switch until the good one arrives in the mail. The switch is normally off and momentarily on. Since the twist grip was stiff, two new bushings solved that problem.
The original two prong plug connector will get trashed in favor of something more modern with two wires instead of three. The original plug would probably look better on a 30’s or 40’s table lamp anyway. 😀
Here’s a little trouble shooting checklist for the PO ignition system.
Hey Viking66, if you are a paid up club member in good standing, why not PM the Admin with your info so you can have your name highlighted in red and gain access to the ‘Members Only’ section on these boards. You’ll see what I did to replace the carb float!
viewforum.php?f=63
Attachments:
