Re: West Bend Commodore 18

[jerry-ahrens]

I haven’t got that far into my lower unit yet, but I do need a new driveshaft seal for sure. I did notice that the driveshaft seal has a part # stamped on the rubber, so maybe you could match it that way. You may get lucky with the Sierra kit.
Keep in mind that I have not yet ran my motor with the above mentioned impeller. If the impeller that came out of mine was the correct one to begin with [ which I think it was] then I should be good to go. If you try the 47-F436065-2 impeller, I would keep an eye on the exaust relief discharge to make sure it’s pumping water well, just to make sure it’s not overheating.