Reply To: Lauson T-653 R Information Request

Home › Forum › Ask A Member › Lauson T-653 R Information Request › Reply To: Lauson T-653 R Information Request

February 2, 2026 at 9:21 pm #304246
JOHN D.
Participant

    US Member

    As far as cutting down the center pole, you will need to cut down both sides. This will allow the coil to slide on without interference. The John Deere coil is large enough and needs to slide in with at least 1/4″ of the center lamination sticking out. This helps to keep the flywheel magnets from hitting the coil.