Reply To: Lauson T-653 R Information Request

Home › Forum › Ask A Member › Lauson T-653 R Information Request › Reply To: Lauson T-653 R Information Request

February 1, 2026 at 10:19 am #304186
JOSEPH BRINCAT
Participant

    US MEMBER PAY BY CHECK

    Thanks “jcr”  that was a timely post. I knew that the armature laminations had to be cut down to 7/16 “to accommodate the JD coil.

    But just for info some details please…  side to side was cut evenly I assume.  How about top and bottom, this affects the vertical position of the coil within the mag plate and clearance to the flywheel.  Did you cut the top ? the bottom ? or even?

    Joe