Reply To: Neptune AA1

[Sam M.]

So my “in general” statement did not apply.  That is not the kind of pin or screw hinge I was thinking off.  Here there is no hinge.  I would think taking off that top clip you found should let the float slide up and off.  Based off of the diagram, you shouldn’t need to worry about the lower clip.  Once the float is off, (and there are no other non-metal pieces attached to the carburetor) you can spray carburetor cleaner through all the passageways to clean it out.  Sometimes, there is no need to take apart every piece.  Then again, I have not worked on your carburetor before so go ahead and investigate!