Re: Bent Lower Unit

[Buccaneer]

Figured I wasn’t out much experimenting with the lower unit, trying
to straighten it. Put it in my vise, sandwiched between some 2x’s,
just above the bend. Stuck some scrap metal inside the bottom of
the lower unit, and slid a two foot pipe over the metal for leverage.
Fired up the cutting torch and heated all around the bend while
applying pressure on the pipe with my side. (Why weren’t we born
with three hands?) Took my time, piddled around for 15 minutes,
but think I have it real close to straight according to my square and
tape measure. Won’t know for sure until I get new bearings, etc.,
and re-install the drive shaft!

Prepare to be boarded!