Reply To: reed valves for old Elgin

Home › Forum › Ask A Member › reed valves for old Elgin › Reply To: reed valves for old Elgin

March 13, 2025 at 4:01 pm #294612
JOSEPH BRINCAT
Participant

    US MEMBER PAY BY CHECK

    Froggy, I think that you have the right process in mind.  Dremel with the thin cut-off wheel should work fine, just go slow and let heat dissipate. I would not try using a drill for the hole, your idea of a small grind stone on the Dremel will work OK, just keep opening  the hole little by little. Small diamond point on the Dremel should do the job as well.

    Report back on your progress & success

    Joe B

     

    Joe B