Reply To: 1924 2hp BNL Johnson runs rough

[Monte NZ]

Success at last!

I fitted the new condenser and gave the points a complete overhaul………the contacts were like a couple of mirrors after I had finished them. I also checked that the timing was correct.

I then found that with this work done, I could now flick the motor over by hand and get an excellent spark, whereas previously I had to turn the motor over with the cord.

The motor started on the second pull and ran well compared to performance prior to the installation of new condenser and points overhaul. but  I still think the motor is running a little bit rough…….your comments would be appreciated.

I have provided a link to two video clips of the motor running so you can see the improvement in performance………as the gearbox is still to be installed, I used my hand to add load to the motor.

https://photos.app.goo.gl/mePX2XtFfb6KWY319

Thanks very much once again everyone for all your help.

Monte NZ