Reply To: OMC Kill-switch question

Home › Forum › Ask A Member › OMC Kill-switch question › Reply To: OMC Kill-switch question

June 28, 2024 at 12:21 am #288684
JACQUES
Participant

    maybe…. you have a break in your ground wires used for killing the engine.   I know you indicated  they tested  0 ohms   but  check  any flex points

     

    see if you can  ohm out the wires  (engine not running)  while   throtling up and down to move the plate.

     

    bending/flexing wires can break  eventually .  Here is  a typical flex brake on HV  wires to spark plugs … it happens !

     

     

    Joining AOMCI has priviledges 🙂