I almost always figure out how to use the casting(s) involved as die cutters. I just lay the gasket material on the part involved and go tapping around the edges with a small ball pein hammer, and use the ball side to create impression marks where the bolt holes are so I can use gasket punches to create the hole.Once the gasket is installed, if there is a lil bit of overhand visible, an Exacto knife takes care of that with surgical precision. Hope this helps.
Best,
PM T2
He's livin' in his own private Idaho..... I hope to go out quietly in my sleep, like my grand-dad did..... and not screaming, like the passengers in his car...
