see M.Mohat articles…. the emptied cap can is simply drilled 1/16 on the bottom or the side near the bottom. one leg of the carb is passed to the outside and welded on the can
the tall can may be fine if it does not rub under the fw
the other end is carefully centered in the can and extended with a small piece insulated stand wire enough to reach the points
just center the cap in the can with epoxy and top of with a dab of clear silicone ( no black silicon) .
Microsoft Word – Part4_Repairing_Broken_Condensers.doc (wrcoutboards.org)
Joining AOMCI has priviledges 🙂
