Home › Forum › Ask A Member › Shift rod seal help › Reply To: Shift rod seal help
I refurbed about 6 turtles but never encountered any problems with the rubber mounts. I ear they are a pia to replace because you have to take the lower housing apart.
there are probabbly some good utubes on how to do it.
my biggest hurdle was trying to fix a friction bolt to keep the engine from flopping around. Also had a busted choke spring so I ordered some piano wire and made one up.
to bad I don’t have piano with all the left over wire I got. 🙂
that nice 9.5 was picked up for $50 cdn took a week to loosen stuck pistons and it has been my best investment in oldys.
to reduce gas $$$ for all day trolling I switched in a nice Merc 4hp … that one was free ! cleaned the carb polished the point and cleaned the lower gc of dirt to open up the water drain hole. That little 4hp purrs all day and sips gas.
Joining AOMCI has priviledges 🙂