Reply To: QD16 tuning

[Rob]

Thanks everyone!!

I pulled the roller off and removed all that silly duct tape. Turns out, it wasn’t in as bad of a shape as it looked from my previous observation. Once I pulled the tape off, the actual roller was in pretty decent condition. So I cleaned it off and put it back on.

Then I adjusted the brass throttle cam until the throttle was just starting to crack open when the roller was in the center of the marks on the magneto. I am going to have to wait until it warms up outside a bit before I can try to run it in my trash can, but I am sure it’s going to be MUCH better.

Thanks again everyone!

-Rob

 

 

Rob