Reply To: Mercury model 40

Home › Forum › Ask A Member › Mercury model 40 › Reply To: Mercury model 40

December 29, 2023 at 9:05 am #283543
JACQUES
Participant

    wire strands likely OK  just brittle  insulalion

    why not cut at a good spot.. off set the cuts  by 1-2 inches  …

    backslide some heat shrink tubing both ways with  a final piece of tubing backslided over  the 2 wires and then positionned across the joints

    or apply lots of liquid tape

     

    don’t forget to  clean out the lower GC cavity of  sandy crud and open up the drain hole !

    Joining AOMCI has priviledges 🙂