Got to spend some time the motor.
This all I have for drive shafts.
I added some weld to the female
side to fit the mail side as best I
could. If I could take the male joint
off I could make a better repair but
its pressed on before a tapered hole
is drilled for impeller pin.
It would be difficult to aligned it.
Used the aluminum brazing rod here.
As usual with this stuff, it worked but
it was difficult and the result is not as
good as I hoped.
Tubs
.
A "Boathouse Repair" is one thats done without having tools or the skills to do it properly.