Home › Forum › Ask A Member › 1969 Evinrude / 1971 Johnson 9.5 Runs Poor › Reply To: 1969 Evinrude / 1971 Johnson 9.5 Runs Poor
Leeroy’Sis just an article on the MQ version not utube… sorry for any confusion part1-2 alluded to specific videos see below
the link sync process is posted above I did see a video about a guy who said the “notch position” was not the perfect place for the cam follower . he adjusted a bit more to the right side of it—>
try the conventional way…. adjust cam follower to just start to open the plate at START when the cam touches it….
small square pump omc ……… fits perfect over the pulse hole if I recall
9.5 Hp Johnson Evinrude Outboard Carburetor Rebuild – 1of2 – YouTube
(125) 9.5 Hp Johnson Evinrude Outboard Carburetor Rebuild – 2of2 – YouTube
Johnson (leeroysramblings.com)
….. There is no aftermarket carburetor kit available for these motors. The BRP part # is 0382048, which includes the float. Available for $30.96 as of 5-2013. I am disappointed in this kit. It comes with, (like most) repair parts for both the early and late carbs but does not come with everything. On this carburetor, there is a 1/2″ core plug on the outer part of the carb that is inline with 3 small holes in the carb throat. These holes had to be drilled through the access hole this core plug covers up. However INSIDE and under the core plug is a plastic filler plug #0312909 that is not included. On the one I repaired, it would be impossible to remove this plastic plug without destroying it. Oh yes, this kit also included a old style fuel pump cover gasket and filter screen.
adjust the side knob … for good idle speed
goind off line for a good while… good luck
Joining AOMCI has priviledges 🙂