Reply To: Old and unusual screw sizes

Home › Forum › Ask A Member › Old and unusual screw sizes › Reply To: Old and unusual screw sizes

March 29, 2023 at 11:52 pm #274581
JOSEPH BRINCAT
Participant

    US MEMBER PAY BY CHECK

    Tim, are you sure about the size… #10- 30 ? that seems very strange and kinda’ small for pulling.   In any case that would be a lathe job, not too difficult.

    Joe B

    PS, no problem with the hammer method if you use a thread protecter ( knocker) and lift up on the flywheel .