Reply To: Another TD 20 idling question

Home › Forum › Ask A Member › Another TD 20 idling question › Reply To: Another TD 20 idling question

January 4, 2023 at 9:39 am #270675
Fastwin18
Participant
    aquasonic wrote:
    aquasonic wrote:

    Try removing the low speed needle, and push the primer with the low speed needle removed. Sometimes this will clear an obstruction.

    Try this again with the replacement needle removed.

    The obstruction was the broken needle point. With the new needle the motor actually responds when I’m turning the low speed needle, whereas previously it wouldn’t. I couldn’t resist giving it another go (work can always wait, right) and now it runs much, much better. Still not as slow as I know they can, but I think I’ll get there with a little bit more time.

    Thank you so much all!