Reply To: 4 hp mercury carb removal

[JACQUES]

the nuts are hard to get at and  there isn’t much  room to access them   and  you needto turn them  by small increments  while pulling the carb body forward.   bit of a pain  but doable.

remove the  choke   nd spring in front of the carb.  remember how it is  hooked up  before removal

actually if you  just  remove the  idle tube on top , the  idle needle  and the  HS orifice  you can probably blast any  obstructions out without taking the carb out.

 

 

Joining AOMCI has priviledges 🙂