Reply To: 1930 Johnson V-45 Crank Bearings

Home › Forum › Ask A Member › 1930 Johnson V-45 Crank Bearings › Reply To: 1930 Johnson V-45 Crank Bearings

December 1, 2022 at 11:12 pm #269605
Buccaneer
Participant

    US Member
    JAY T. WALLS wrote:

    So, if you haven’t got the head off yet I’d suggest you do as George suggests and take the whole cylinder off with the head on it. With it off you can turn it over and use a 2 x 4 rounded up to fit the 2 3/8ths bore. Use the 2 x 4 as a punch to push the head off from the inside. A couple hits on one side then the other to try to bring the head off evenly. A couple of suggestions are not to try pulling on sparkplug threads. They will pull out. Take the sparkplugs off as the suction they make while installed makes it harder to remove the cylinder.

    I gave up on taking the head off for now. I finished putting the motor back together,
    and did about a 30 second test run on the stand. I didn’t hear any objectionable
    noises, but the real test will be when and if I get it on the boat!

    Prepare to be boarded!