Reply To: 1947 Evinrude 4416

Home › Forum › Ask A Member › 1947 Evinrude 4416 › Reply To: 1947 Evinrude 4416

August 28, 2022 at 8:19 am #265063
William MacNeill
Participant

    Thanks again Tubs. I’ll try this today.  Compression is at 60 in the cylinder.  Not sure if that is considered low for this motor. Also the intake manifold gasket for the carb is indented on the covered side as if it was sucked in. Not sure what that is about.  I think the gasket is ok but if I could replace it I would.  Not sure who the manufacturer of the carb is to see if a gasket can be had.