Don’t know if I’m going down an unnecessary rabbit hole on this one.
Not knowing anything about fluid dynamics, and carburetor theory I have another question.
Before it was determined that the float bowl gasket was incorrect, I was searching for any differences I could find between the bowl with the casting for the choke solenoid that I changed to from a 33HP from my original bowl from my 28HP possibly causing the non run issue.
Looking at part numbers the bowl nozzle was different for the bowl with the solenoid. It had an extra hole. I picked one up. Should I use it, or did the engineers at OMC just use it because of the 5HP difference and various other changes they made to the 33?
Thanks,
Bob D
