Reply To: Getting the gas out when you’re done using a motor.

Home › Forum › Ask A Member › Getting the gas out when you’re done using a motor. › Reply To: Getting the gas out when you’re done using a motor.

May 28, 2022 at 9:16 pm #260588
Jorzo211
Participant
    Tom wrote:

    I use an OMC primer bulb in the middle of a 4′ length of fuel hose.  I have about a foot of 3/8″ copper tubing jammed into the inlet end which lets me get to the far reaches of tanks as necessary.  Use copper, NOT anything that might spark.  Just drop the copper tubing end into a tank of gas, the other end in your portable tank, and squeeze the primer bulb.

    Tom

    I was use the same setup to get the fuel out of my pressure tank. Take a little bit of squeezing but it works great

    MARK-7, KF-7, KE4-A, MARK 15, WN7A, (60)MERC 200