Reply To: Elto Rudder Twin

[Tom]

There should be a long two conductor wire, a short two conductor wire, and one spark plug wire coming out one side.  Only a spark plug wire coming out the other side.

Remove the timer, tank, and coil brackets.  Put the tank in place, install the coil with the brackets on top of the tank bosses, then finish installation of the tank.

Route the short wire up and into the bottom of the timer.  Attach one conductor to the insulated points terminal.  Attach the other to the kill switch inside the timer.  Install the timer.

Place the timer strap in place on the timer and install the flywheel so that the cam goes into the large end of the timer strap.

Install one spark plug and attach the spark plug wire to the spark plug.   Attach the other wire to the other plug, but leave it resting on the cylinder.

Hook the long wire conductors to a 6 or 7.2 volt battery of at least an amp-hour or so.  Place the timer all the way to the left.  Turn the flywheel counter clockwise against compression  until you hear a click.  When you do, you should see a spark at the plug resting on the cylinder.

T