Before I stopped putting a sealer on corks I
tried Kreem fuel tank sealer. I bushed on 3
coats (as I remember). It seemed to be working
fine until after about 3 years I went to use the
motor and the float bowl was running over.
Found that the sealer had separated from the
cork and the cork was stuck in the float bowl.
I cant say for sure but I suspect gas got under
the sealer at the hole for the float pin (needle).
The increase in weight didn’t seem to be a
problem. If your going to try it I’d suggest you
check it each time before you plan to use the
motor. This was a motor I used quite a bit so
it took a while. I have used both Kreem & Red
Koat sealers. Both state to use acetone to
remove them.
Tubs.
A "Boathouse Repair" is one thats done without having tools or the skills to do it properly.