Reply To: How does one install Spark Plug Wire Spring Terminals?

[Marion Hansen]

An approach:
1) Slide rubber boot on the end of the wire (Yes, some WD40 first),
2) Move boot onto wire until about 1/4″ of wire protrudes past big end of boot,
3) Grab the coil part with a pliers,
4) Place coil against end of wire,
5) Press barb through rubber until the wire section between the barb and coil is parallel and against the rubber of wire,
6) Slide boot over end of wire until coil is in the center of the big end of the boot.