There is no way that was working. Its
often a challenge to get the right parts to
seal good enough so the curb doesn’t run
over. With luck the seat isn’t damaged.
PM me your address and I’ll send you a
float pin and a couple clips to position
the cork you can try.
This Pal Carb has the mixing valve and
the float bowl compiled. Many others.
Tubs
Great picture Tubs. I may have a spare gloat pin in my parts stash. What motor is the pin from that you had in mind?
And I agree. The PO flattened the nail and drilled a hole to route the wire. Pretty ingenious but that’s probably why the motor got parked. 