Reply To: Changing a stop button to a kill switch lanyard on an FDL-18

Home › Forum › Ask A Member › Changing a stop button to a kill switch lanyard on an FDL-18 › Reply To: Changing a stop button to a kill switch lanyard on an FDL-18

February 15, 2022 at 7:49 pm #254706
JACQUES
Participant

    basic  layout to kill a magneto … see picture

    essentially   the idea  is to interconnect both sets of points to kill   the engine so a NORMALLY  OPEN contact…  is needed somewhere  in the boat

    Be it a “push to kill”  on the motor,  a key switch to go OFF   or… a lanyard   all these methods will  ultimately  link 2 magneto  wires to rejoin the points  to  kill the ignition

     

     

     

    Joining AOMCI has priviledges 🙂

    • This reply was modified 4 years, 8 months ago by JACQUES.