Reply To: Changing a stop button to a kill switch lanyard on an FDL-18

Home › Forum › Ask A Member › Changing a stop button to a kill switch lanyard on an FDL-18 › Reply To: Changing a stop button to a kill switch lanyard on an FDL-18

February 15, 2022 at 7:24 pm #254695
frankr
Participant

    I’m not familiar with any 6-post lanyard switch.  Is it also an electric start/key switch?  Whatever, last resort is check it out with a continuity light or multimeter.  Identify two terminals that have continuity with the lanyard pulled, but no continuity with lanyard attached.  (They may be marked “M”).  Extend your present push button wires to those two terminals thus identified.  Makes no difference which wire to which terminal.  You can leave the present kill button connected too.