Home › Forum › Ask A Member › 1976 Evinrude 15 hp 15604A Fuel pump? › Re: 1976 Evinrude 15 hp 15604A Fuel pump?
I have done it … with my fat fingers .. you can do it to ….. but READ this link 3 times and understand it before you proceed !!!!
glue the little springs on their respective plastic nipple base and then glue the little mushrooms pads onto their springs with just a small dab of Krazy glue ( minimum) on the springs and pads . Let the glue set
the glue holds the parts in place while you mount the diaphragms over them and layer up the pump. layer up the pump by using the 2 mounting bolts . Make sure the pump orients properly like the original layout on your engine
when done check by blowing air fuel inlet to fuel outlet NO AIR should pass if you blow in the reverse direction !!!
Voila.. your done ! 🙂
Crosbyman,
I too have had success with this, but like you said, read and understand it all as much as possible before you start. The first one I tried took more than one go at it before I got it right.
It can be done.