I received these coils yesterday and they seem to match up except for one thing: the solder button, where you would attach the plug wire, falls dangerously close to the ignition plate at the bottom. It’s not exactly in the same position as the original coils, which I think, are scintilla coils. Does anyone know a way to get around this? Even with the rubber boot (that encases and insulates the plug wire from the housing on the bottom of the coil) attached, the soldered connection would be 1/8” from the metal ignition plate, which, to me….literally begs to short out. How can I get around this?
I might add that the coil could be rotated 180 degrees, which puts the solder button on top of the coil, but in that configuration it might invite clearance problems with the flywheel.
As usual, any help is very valuable and deeply appreciated! Photo attached.
