Reply To: Bronze rod bearing clearance. Spare the rod?

Home › Forum › Ask A Member › Bronze rod bearing clearance. Spare the rod? › Reply To: Bronze rod bearing clearance. Spare the rod?

September 17, 2021 at 12:12 pm #246791
Tom
Participant

    US Member

    I see that the rod for the Maytag 82 has no end cap, so that route is out. Assuming the crank bearings are good, you might consider checking in with one of the Maytag collector sites on Facebook, or Harry’s Old Engine page. Likely the rod will need to be bored round, bushed, then reamed to fit the crankpin.

    T